So, here is the description of my Acer Aspire 1410 Bluetooth Module install, and what to be careful of:
1. Shutdown Acer Aspire 1410 Netbook, unplug A/C adapter, remove battery.
2. Ground self to metal USB, VGA, or HDMI to remove static electricity.
3. Remove keyboard by pressing down to release tiny black tabs (4 at rear and 1 on each side).
4. Remove keyboard blue cable by lifting black connection lever with thumbnail.
5. Remove screws under keyboard labeled "M2x3L" and "M2x5L" (3 silver M2-3L and 6 black M2X5L).
6. Remove blue mouse pad cable by lifting black connector lever with fingernail.
7. Close display and flip over to expose bottom of Acer Aspire 1410 Netbook.
8. Remove hard drive cover with the 2 black M2X5L screws.
9. Lift cream colored hard drive gold cable connector with two fingernails or small flat screwdriver prying up gradually on each side.
10. Remove hard drive by pulling the clear plastic pull tab.
11. Loosen 12 black M2X5L screws on bottom, then flip the 1410 over on a towel to capture all 12 screws.
12. Flip Acer Aspire 1410 Netbook over right side up.
13. Lift top case that surrounds keyboard with fingers and release tiny black tabs on inside of display hinges by pressing in with tiny flat screwdriver while lifting top case around hinge areas.
14. Connect Bluetooth Module Cable to module with white connector.
15. Place Bluetooth Module in carrier on lower case by pressing down onto existing clear double stick tape and plastic guide pins to lock-in module.
16. Plug Bluetooth Module Cable black connector into white motherboard plug.
17. (*Very Important*) From Bluetooth module, run cable down into existing cable slot on lower case toward other wires and tuck excess cable under motherboard. *If this is not done to route Bluetooth Cable properly, the cable will interfere with the mouse right-click button, which will cause the mouse pad not to work.
18. Reassemble making sure that hard drive, mouse pad, and keyboard connections are proper, in this order: Top case snap in black tabs by hinges, hard drive, hard drive cover, bottom 12 screws, mouse pad cable, 9 screws under keyboard, keyboard cable, and keyboard.
19. Install battery and turn on the Acer Aspire 1410 11.6 inch display Netbook.
20. Turn on the Bluetooth using the switch at the left-front of the case, next to the Wi-Fi switch.
21. Download the proper driver (Vista, XP, or whatever you reloaded the 1410 with), and unzip to the "C" drive or desired location.
22. Use the automatic driver install wizard that starts to browse to the driver folder, and finish the driver install.
23. Use the newly installed Bluetooth as desired
.